The graphic can be applied to a window using a squeegee that is covered with a non-abrasive sleeve to prevent scratching. Before application, clean the window thoroughly with a suitable glass cleaner such as Isopopyl Alcohol. Be sure no residue from the cleaner is present during application.

Measure the decal to be applied and be sure the graphic fits into the window with a clearance around any rubber gasket. To place the graphic on the window, use low tack tape at the top of the image. Flip the graphic up using the low tack tape as a hinge and start removing the liner from the graphic. Start the squeegee action in the middle of the image, from one side to the other. All exposed edges should and seams must be sealed with edge sealer.

Wet application method is not recommended for perforated window film graphics. Water will be trapped in holes causing vision to be obscured when looking through graphics.

During removal, lift a corner of the decals and pull slowly at an angle approximately 450 to 750. If the adhesive residue or edge sealer is left on the substrate, use a cloth soaked in mild detergent and use a squeegee to scrap off the adhesive stains.